Nous croyons que pas mal de candidats voient les autres site web qui offrent les ressources de Q&A Cisco 640-816. En fait, le Pass4Test est le seul site qui puisse offrir la Q&A recherchée par les experts réputés dans l'Industrie IT. Grâce à la Q&A de Pass4Test impressionée par la bonne qualité, vous pouvez réussir le test Cisco 640-816 sans aucune doute.
Avec l'aide du Pass4Test, vous allez passer le test de Certification Cisco 640-816 plus facilement. Tout d'abord, vous pouvez choisir un outil de traîner de Cisco 640-816, et télécharger les Q&A. Bien que il y en a beaucoup de Q&A pour les tests de Certification IT, les nôtres peuvent vous donner non seulement plus de chances à s'exercer avant le test réel, mais encore vous feront plus confiant à réussir le test. La haute précision des réponses, la grande couverture des documentations, la mise à jour constamment vous assurent à réussir votre test. Vous dépensez moins de temps à préparer le test, mais vous allez obtenir votre certificat plus tôt.
Les produits de Pass4Test sont recherchés par les experts de Pass4Test qui se profitent de leurs connaissances et leurs expériences dans l'Idustrie IT. Si vous allez participer le test Cisco 640-816, vous devez choisir Pass4Test. La Q&A de Pass4Test peut vous aider à préparer mieux le test Cisco 640-816 avec sa grande couiverture des questions. En face d'un test très difficile, vous pouvez obtenir le Certificat Cisco 640-816 sans aucune doute.
Obtenez la Q&A de test Cisco 640-816 de Pass4Test plus tôt, vous pouvez réussir le test Certification Cisco 640-816 plus tôt.
Code d'Examen: 640-816
Nom d'Examen: Cisco (Interconnecting Cisco Networking Devices Part 2)
Questions et réponses: 222 Q&As
640-816 Démo gratuit à télécharger: http://www.pass4test.fr/640-816.html
NO.1 How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be
configured to allow connectivity between all devices?
A. The ports only need to be connected by a crossover cable.
B. SwitchX (config)# interface fastethernet 0/1
SwitchX (config-if)# switchport mode access
SwitchX (config-if)# switchport access vlan 1
C. SwitchX (config)# interface fastethernet 0/1
SwitchX (config-if)# switchport mode trunk
SwitchX (config-if)# switchport trunk vlan 1
SwitchX (config-if)# switchport trunk vlan 10
SwitchX (config-if)# switchport trunk vlan 20
D. SwitchX(config)# interface fastethernet 0/1
SwitchX(config-if)# switchport mode trunk
Answer: D
Cisco examen 640-816 640-816 examen 640-816 examen
NO.2 Which of these represents an IPv6 link-local address?
A. FE80::380e:611a:e14f:3d69
B. FE81::280f:512b:e14f:3d69
C. FEFE:0345:5f1b::e14d:3d69
D. FE08::280e:611:a:f14f:3d69
Answer: A
Cisco examen 640-816 examen 640-816 640-816
NO.3 The network technician is planning to use the 255.255.255.224 subnet mask on the network.
Which three valid IP addresses can the technician use for the hosts? (Choose three.)
A. 172.22.243.127
B. 172.22.243.190
C. 172.22.243.191
D. 192.168.1.160
E. 10.17.64.34
F. 10.16.33.98
Answer: BEF
Cisco 640-816 640-816
NO.4 Refer to the exhibit.
Based on the output of the R1# show ip route command and the information presented in the graphic,
which of the following is a potential routing problem?
A. the use of summarization for discontiguous networks
B. the use of CIDR with a routing protocol that does not support it
C. the use of VLSM with a routing protocol that does not support it
D. the use of the no auto-summary command with a protocol that does not support summarization
E. the use of the ip route 0.0.0.0 0.0.0.0 command with a routing protocol that does not support it
Answer: A
Cisco examen 640-816 examen certification 640-816 640-816
NO.5 What are two characteristics of a switch that is configured as a VTP client? (Choose two.)
A. If a switch that is configured to operate in client mode cannot access a VTP server, then the switch
reverts to transparent mode.
B. On switches that are configured to operate in client mode, VLANs can be created, deleted, or renamed
locally.
C. The local VLAN configuration is updated only when an update that has a higher configuration revision
number is received.
D. VTP advertisements are not forwarded to neighboring switches that are configured in VTP transparent
mode.
E. VTP client is the default VTP mode.
F. When switches in VTP client mode are rebooted, they send a VTP advertisement request to the VTP
servers.
Answer: CF
Cisco certification 640-816 640-816
NO.6 Which two statements are true about interVLAN routing in the topology that is shown in the exhibit?
(Choose two.)
A. Host E and host F use the same IP gateway address.
B. Router1 and Switch2 should be connected via a crossover cable.
C. Router1 will not play a role in communications between host A and host D.
D. The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces.
E. Router1 needs more LAN interfaces to accommodate the VLANs that are shown in the exhibit.
F. The FastEthernet 0/0 interface on Router1 and Switch2 trunk ports must be configured using the same
encapsulation type.
Answer: DF
Cisco 640-816 examen 640-816
NO.7 A network administrator cannot establish a Telnet session with the indicated router. What is the cause of
this failure?
A. A Level 5 password is not set.
B. An ACL is blocking Telnet access.
C. The vty password is missing.
D. The console password is missing.
Answer: C
Cisco certification 640-816 certification 640-816 640-816 640-816 examen 640-816 examen
NO.8 A department decides to replace its hub with a Catalyst 2950 switch that is no longer needed by another
department. To prepare the switch for installation, the network administrator has erased the startup
configuration and reloaded the switch. However, PCs that are connected to the switch experience various
connectivity problems. What is a possible cause of the problem?
A. The VLAN database was not erased.
B. The management VLAN is disabled.
C. The running configuration should have been erased.
D. The "mode" button was not pressed when the switch was reloaded.
E. The switch was not configured with an IP address or a default gateway.
Answer: A
certification Cisco certification 640-816 certification 640-816 certification 640-816
NO.9 The following commands are executed on interface fa0/1 of 2950Switch.
2950Switch(config-if)# switchport port-security
2950Switch(config-if)# switchport port-security mac-address sticky
2950Switch(config-if)# switchport port-security maximum 1
The Ethernet frame that is shown arrives on interface fa0/1.
What two functions will occur when this frame is received by 2950Switch? (Choose two.)
A. The MAC address table will now have an additional entry of fa0/1 FFFF.FFFF.FFFF.
B. Only host A will be allowed to transmit frames on fa0/1.
C. This frame will be discarded when it is received by 2950Switch.
D. All frames arriving on 2950Switch with a destination of 0000.00aa.aaaa will be forwarded out fa0/1.
E. Hosts B and C may forward frames out fa0/1 but frames arriving from other switches will not be
forwarded out fa0/1.
F. Only frames from source 0000.00bb.bbbb, the first learned MAC address of 2950Switch, will be
forwarded out fa0/1.
Answer: BD
certification Cisco 640-816 640-816 examen 640-816 examen 640-816 640-816
NO.10 The network administrator has been asked to give reasons for moving from IPv4 to IPv6.
What are two valid reasons for adopting IPv6 over IPv4? (Choose two.)
A. no broadcast
B. change of source address in the IPv6 header
C. change of destination address in the IPv6 header
D. Telnet access does not require a password
E. autoconfiguration
F. NAT
Answer: AE
certification Cisco 640-816 certification 640-816 640-816
NO.11 What is the most appropriate summarization for these routes?
A. 10.0.0.0 /21
B. 10.0.0.0 /22
C. 10.0.0.0 /23
D. 10.0.0.0 /24
Answer: B
Cisco examen 640-816 640-816 examen 640-816
NO.12 Why has this switch not been elected the root bridge for VLAN1?
A. It has more than one interface that is connected to the root network segment.
B. It is running RSTP while the elected root bridge is running 802.1d spanning tree.
C. It has a higher MAC address than the elected root bridge.
D. It has a higher bridge ID than the elected root bridge.
Answer: D
Cisco examen certification 640-816 640-816 640-816
NO.13 What are three characteristics of the OSPF routing protocol? (Choose three.)
A. It converges quickly.
B. OSPF is a classful routing protocol.
C. It uses cost to determine the best route.
D. It uses the DUAL algorithm to determine the best route.
E. OSPF routers send the complete routing table to all directly attached routers.
F. OSPF routers discover neighbors before exchanging routing information.
Answer: ACF
Cisco examen 640-816 examen 640-816 640-816 examen 640-816 examen 640-816
NO.14 A network administrator needs to configure port security on a switch.
Which two statements are true? (Choose two.)
A. The network administrator can apply port security to dynamic access ports.
B. The network administrator can apply port security to EtherChannels.
C. When dynamic MAC address learning is enabled on an interface, the switch can learn new addresses,
up to the maximum defined.
D. The sticky learning feature allows the addition of dynamically learned addresses to the running
configuration.
E. The network administrator can configure static secure or sticky secure MAC addresses in the voice
VLAN.
Answer: CD
Cisco examen certification 640-816 640-816 examen certification 640-816
NO.15 An administrator is troubleshooting a problem between routers that are using different versions of RIP.
Which two commands would provide information about which version of RIP was being sent and received
on an interface? (Choose two.)
A. show ip protocols
B. show ip route rip
C. show interfaces
D. debug rip routing
E. debug ip rip
Answer: AE
Cisco 640-816 examen 640-816 examen 640-816 examen
NO.16 Which protocol provides a method of sharing VLAN configuration information between two Cisco
switches?
A. STP
B. VTP
C. 802.1Q
D. RSTP
Answer: B
certification Cisco 640-816 certification 640-816 640-816 640-816 640-816 examen
NO.17 At which layer of the OSI model is RSTP used to prevent loops?
A. physical
B. data link
C. network
D. transport
Answer: B
certification Cisco certification 640-816 certification 640-816 640-816 examen 640-816
NO.18 Refer to the exhibit.
Which two statements are true about the loopback address that is configured on RouterB? (Choose two.)
A. It ensures that data will be forwarded by RouterB.
B. It provides stability for the OSPF process on RouterB.
C. It specifies that the router ID for RouterB should be 10.0.0.1.
D. It decreases the metric for routes that are advertised from RouterB.
E. It indicates that RouterB should be elected the DR for the LAN.
Answer: BC
certification Cisco 640-816 certification 640-816
NO.19 The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the
graphic.
There is concern that a lack of router resources is impeding internetwork performance. As part of
examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the
default and the router IDs are shown with each router.
Which routers are likely to have been elected as DR? (Choose two.)
A. Corp-1
B. Corp-2
C. Corp-3
D. Corp-4
E. Branch-1
F. Branch-2
Answer: DF
certification Cisco 640-816 640-816 640-816 examen
NO.20 Which two of these statements regarding RSTP are correct? (Choose two.)
A. RSTP cannot operate with PVST+.
B. RSTP defines new port roles.
C. RSTP defines no new port states.
D. RSTP is a proprietary implementation of IEEE 802.1D STP.
E. RSTP is compatible with the original IEEE 802.1D STP.
Answer: BE
Cisco 640-816 certification 640-816 certification 640-816
Si vous voulez ne se soucier plus à passer le test Cisco 640-816, donc vous devez prendre la Q&A de Pass4Test comme le guide d'étude pendant la préparation de test Cisco 640-816. C'est une bonne affaire parce que un petit invertissement peut vous rendre beaucoup. Utiliser la Q&A Cisco 640-816 offerte par Pass4Test peut vous assurer à réussir le test 100%. Pass4Test a toujours une bonne réputation dans l'Industrie IT.
没有评论:
发表评论